Multi Kruzer - Changing the Depth reading from Metric to Inches (1 reply)

Hi,

I think I made a discovery. I do not mean to be critical in any way. Just want to let everyone know in case they have the same issue

My Multi Kruzer came with the Depth Meter set for Centimeters - You can see in the Manual there is a way to change the depth reading to Inches.

(See Below what I copied from the Manual)

IMPORTANT! If you want the target depth to be displayed in inches instead of cms please do the following: While the device is off, press and hold the SELECT and OPTIONS buttons simultaneously and turn the device on. ''In'' will be displayed. To switch back to cms, you need to turn the device off and then repeat the above procedure. While the device is initializing, ''SI'' will be displayed.

I believe there may be a misprint in the Manual.

I can only change my unit by by holding down the

"Settings" and "Option" buttons while turn the unit on.

I tested this several times without an issue

Happy Hunting All:detecting: