Quick hunt before the rain turned into a history lesson (3 replies)
Hunting buddy had to work so our hunt got put on the back burner till tomorrow. After the honey do's I had just enough time to hit a spot so loaded up the 4W. Got off the 4wheeler and dialed in the...
View ArticleCan't set gain above 39 (5 replies)
Anything above 39 will overload. Tried it in several places away from EMI with the stock 11" coil. Still managed to get a good hunt in even at 39 gain. I've been able to run my gain as high as I want...
View Articlesame problem again (2 replies)
DEAR : I have same problem again , when I find any target then i start to make a hole like 7 or 10 cm then i try to find the targetby mmachine and it's already go outside the hole left or right so...
View ArticleFirst Offical Find (no replies)
My first official find in my front yard, I assume they have been there since the late 60s or 70s because we built the house in 1990 and these were pretty deep aside from the dime I was only able to...
View ArticleTwo Hour Hunt Finds. :-) :ukflag: (2 replies)
I went to a well worked park today with the racer , i have hit this site with many detectors & expected to find nothing at all much. I was surprised to be digging every few minutes Depths were all...
View ArticleThe Racer is too Deep. (no replies)
I dont know if any one else has had the problem of too much depth with the racer but i have had to give up digging on some targets as they were too far down, what the targets were i don't know but...
View ArticleNeed to Call Makro re problem (1 reply)
I have emailed Makro on 2 separate occasions about an overload problem with the 11" DD stock coil. This only occurs in 2-tone, not 3-tone. So far, they have not responded to either of my emails (I...
View ArticleWeight on the 10x5.5 coil ? (2 replies)
Hi guys, I was wondering if anyone could tell me how much less weight the 10x5.5 coil is compared to the stock coil . Thanks, GS
View ArticleClik here to view.
Racer and old house lot again.... (no replies)
House is gone now as of last week, was built in 1916 I believe. Racer and small coil in dense trash, stock settings and ground balanced at 70. Got a 50 and 64 Rosie, a couple of wheats and others.
View ArticleRacer Scores a Merc (3 replies)
Wouldn't have given much for what I though was left in this section of park but the Racer came though. Won't name names but I have worked it very hard many times.. Really getting some accuracy now by:...
View ArticleTarget ID for Silver (1 reply)
Does anyone know the target ID for silver coins using makro racer?
View Article3 tone or 2 tone? (11 replies)
Which one is better and why? what should I be using Pros: if any. Cons: if any.
View ArticleINSIDE SALT WATER (2 replies)
DEAR : i would like to use my, makro racer machine inside the salt beach water only until last low rod and I will protect the control of any water so i will use my machine inside the water until 50 or...
View ArticleBeen lurking, learning. New Racer is on the way to me. (6 replies)
I've been on the lookout for a light weight high performing detector that can deal with bad ground. The you tube video I saw with the red Culpepper Va. soil in a tub with the target beneath it...
View Articlemakro racer inside the salt water (no replies)
Today i used my machine inside the water and when I did that i think many time before to do it but i can say yes yes congratulations makro racer you are the stronger machine can accept everything the...
View ArticleIs anyone using the racer for (4 replies)
hunting civil war relics. If so, how's it doing
View Articleracer in modern trash with very little iron. (8 replies)
Hi Guys, What is the racer like in modern trash a lot of aluminium . Can you separate the aluminium or do you have to dig it all. Regards Below2doe.
View ArticleFound in one hole (no replies)
Bought a new car this weekend and decided to do a little detecting with the Racer on the way back to town. Went to a park that has been pounded to death over the years but still coughs one up now and...
View Article